If there is no IP address, please move to step 4. Wait for a few minutes and check the Internet part on the Status page, if it shows any IP address (similar as below), that means the connection between the Router and the Modem is established. Select Dynamic IP as the Internet Connection Type on the right of the web page, shown as below. Log in to the router’s web-based interface, to get some help, please refer to the article How do I log into the web-based Utility (Management Page) of TP-Link wireless router? Here takes Archer C7_V5 as a demonstration. If the direct connection doesn’t work, please contact your Internet Service Provider. Note: Please make sure you are able to access the internet with a direct connection from the main computer to your cable modem. Or you can refer to the Quick Installation Guide in the packet to connect the hardware. Note: If the 2.4 GHz LED and 5 GHz LED are off, press and hold the WPS/Wi-Fi button on the back for more than 2 seconds. Check for the LEDs to confirm the hardware connection, then refer to the following step to setup Connect the power adapter to the router and turn it on.Ħ. This is not my preferred solution as there is a NAT behind a NAT now.ĭoes anyone know what i should be looking at to solve this problem? Power levels in modem seem to be fine, so i am thinking its not an ISP issue, though knowing Rogers, I am not 100% convinced it isnt.Archer C1200, Archer C5400, Archer A2600, Archer AX55, Archer C4, Archer C5200, Archer AX53, Archer C5, Archer AX10, Archer C2, Archer AX51, Archer AX96, Archer D50, Archer C5v, Archer A2200, Archer C6U, Archer C80, Archer AXE95, Archer C8, Archer AX10000, Archer C3150, Archer C9, Archer AX50, Archer C6, Archer C7, Archer AX90, Archer AX6000, Archer CR700, Archer C5400X, Archer C25, Archer C24, Archer A20, Archer A64, Archer C60, Archer C2600, Archer A1200, Archer C21, Archer C20, Archer C64, Archer AX1800, Archer AX206, Archer C59, Archer C58, Archer AX4200, Archer C3200, Archer C900, Archer A2, Archer AX75, Archer AX4400, Archer C3000, Archer AX73, Archer C50, Archer A10, Archer A54, Archer AX4800, Archer C50, Archer C1900, Archer C55, Archer C54, Archer A2300, Archer C20i, Archer AXE75, Archer A6, Archer A7, Archer AX72, Archer AXE200 Omni, Archer A5, Archer GX90, Archer A8, Archer A9, Archer AX68, Archer D2, Archer C2300, Archer AX5300, Archer AX23, Archer D5, Archer AX20, Archer C4000, Archer AX21, Archer A3000, Archer C2700, Archer D20, Archer C7i, Archer AXE300, Archer AX1500, Archer C90, Archer AX60, Archer AX11000, Archer AX3200, Archer AX3000īefore you start, you can refer to the Video first:ġ .Unplug your modem, and remove the backup battery if it has one.Ģ .Connect the powered-off modem to the router’s Internet port with an Ethernet cable.ģ .Power on the modem, and then wait about 2 minutes for it to restart.Ĥ. So far, seems to have stopped the random disconnects from ISP. ISP Tech put modem in gateway mode for testing. I recently reverted to stock openwrt image to try and eliminate bad configuration, with no success. I am unable to read logs on the modem (doesnt seem to store any.Rogers/canada ISP) Nothing in system log tells me why this would be happening. Randomly 3 times an hour the modem will disconnect from ISP. wrt1900ac set as dumb ap with 802,11r w/ wired trunk setup between the two wrts.wrt3200acm as router/wireless AP (ADGuard Home/firewall installed).I have a strange issue and I am not sure how to proceed. Hopefully posting this in correct category.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |